Specifications :
ADSL Specification Compliance
ANSI T1.413 Issue2
ITU-T G.992.1 (G.dmt)
ITU-T G.992.2 (G.lite)
ITU-T G.994.1 (G.hs)
ITU-T G.992.3 ADSL2 G.dmt.bit
ITU-T G.992.4 ADSL2 G.lite.bis
ITU-T G.992.5 ADSL2+
Auto-negotiating rate adaptation
Annex A (ADSL over POTS) , Annex L(ReADSL)
Maximum downstream rate of 24 Mbps and upstream rate of 1 Mbps
Supports Dying Gasp
Software Specification
RFC-1483/2684 LLC/VC-Mux bridged/routed mode
RFC-1577 Classical IP over ATM
RFC-2516 PPPoE
RFC-2364 PPPoA
RFC-1661 PPP
Bridge/Routing
DHCP Client/Sever/Relay
IP routing : RIP v1/v2
Static route
DNS Relay Agent
Dynamic DNS
IGMP Proxy
802.1d Spanning-Tree Protocol
NAT (Network Address Translation)
NAPT port forwarding
DMZ support
Security
User authentication for PPP
PAP (Password Authentication Protocol)
CHAP (Challenge Authentication Protocol)
Firewall
IP/Port filtering
MAC filtering
ATM
ITU-T 1.610 F4/F5 OAM send and receiver loop-back
ATM QoS : CBR, rt-VBR, nrt-VBR and UBR
Multiple PVC : support 8 PVCs
Management
Web-based configuration
Telnet remote management
SNMP v1/v2/Trap
Diagnostic tool
Firmware upgrade through FTP, TFTP and HTTP
UPnP support
ACL (Access Control List)
Hardware Interfaces
4x RJ-45 ports for 10/100 Base-T Ethernet LANs connect to PC
1x RJ-11 port for ADSL connects to WAN
1x reset button to default setting
1x power jack
1x power switch on/off
LED indicators
Power Specification
Environmental Specification
Temperature:
-0 to 40 degrees C (Standard Operating)
-40 to 70 degree C (Non-operating)
Humidity:
-10% to 90% (Non-condensing, Standard Operating)
-5% to 95% (Non-condensing, Non-operating) |